Mason Sand for Patios in Courtland, VA

If you are laying a patio, you need gravel and aggregate delivery in Courtland, VA that starts below the pavers. Virginia Rock Supply sends bulk material across Southampton County, and most patio jobs here open with 21A for the base. The flat ground in this part of Hampton Roads drains slowly, so what you put under the stone matters as much as the stone itself.

Materials for Courtland Projects

In Courtland, patio and flatwork jobs depend on a bedding layer that stays put. You want a base that compacts hard, a leveling course that stays flat, and sand that locks the joints without turning to mud. These are the materials that do that here.

Start with 21A. It has enough fines to pack hard under a plate compactor, which is what keeps a patio from settling at the corners. Build it in lifts and wet it as you go.

On top of that base, screenings give you the dead-flat bedding course pavers need. Stone dust rakes out smooth, holds a screed line, and does not shift once the pavers go down. For the joints, mason sand sweeps in tight and stays put.

Where a patio meets a wall or a low spot, add #8 crushed stone as a drainage layer. It is small enough to bed pipe and porous enough to let water move instead of ponding. If your patio sits on a driveway entrance, #57 stone is the standard washed size for drainage and topping.

Ground and Conditions in Courtland

Skimping on the base is what usually sinks a Courtland patio. Cut the base to an inch or two and the pavers rock within a season, because the ground under them is sand, silt and clay laid down as old sea and river sediment, not weathered rock.

Sandy spots drain fast. Clayey, marshy low ground does not, and flat land gives water nowhere to run. That is why a patio on low ground needs a deeper compacted base and a stone drainage edge, not just more sand.

Heavy rain from tropical storms, nor'easters and summer thunderstorms ponds on drives and pads, and near the tidal rivers storm tides add standing water. Build the base so water has a path out.

Hard freezes are short, so patio work runs through most of the winter. Long wet spells and the late-summer storm season are what hold jobs up, especially on low lots that hold water. Frost depth is set by each locality here, so check your own before you set footing depth.

Delivery to Courtland and the Surrounding Area

Order online and pick your material by the ton or by the cubic yard. Tons work best for stone and base, since weight is what you are paying for. Yards are easier for sand, topsoil and mulch.

Estimate quantity before you order. For a patio base, multiply length by width by your compacted depth in feet, then divide by 27 for cubic yards. Add a little for compaction. The site calculator does the math if you would rather not.

Bulk delivery drops on your site in Courtland or nearby in Southampton County, including Sedley, Boykins, Newsoms, Ivor and Capron. Have the pad cleared and the truck path firm so the load lands where you want it.

Questions from Courtland Builders

What gravel is best for a driveway in Courtland?

21A is the standard Virginia driveway base. Top it with driveway gravel or #57 stone for a cleaner surface. On low, wet ground, build the 21A deeper and add a stone drainage edge so water does not sit under the drive.

How much material will my project need?

Measure the area and the compacted depth you want, then figure volume in cubic yards. Base stone goes down as the thicker compacted layer for a patio, and sand bedding adds a thin layer on top. Add roughly 10 percent for compaction and waste, and size the order from that number.

Get Your Patio Base Sized Right

Run your patio dimensions through the calculator to turn depth into tons, then order 21A, screenings and mason sand in one delivery. Virginia Rock Supply sends bulk aggregate across Courtland and Southampton County, sized to the job. Place your order when your numbers are ready.